Opis
Timer with three adjustable time intervals and two time channels. Both times can be combined differently. Time range 0–999sec, 0–999min, 0–999h, settings apply to both channels simultaneously.
Technical parameters:
– power supply: 12 V
– 6 operating modes – see below
– relay contact 230VAC / 10A or 12VDC / 20A
– dimensions: 48 × 29 mm
– consumption in idle mode: 20 mA
– consumption with closed relay: 120 mA
– panel opening: 45.5 × 26 mm
Operating modes:
– P1–0: the relay closes permanently after time T1 has elapsed
– P1–1: the relay is closed for T1, then it switches off permanently
– P1–2: the relay closes for time T2 after the time T1 has elapsed, then the module is idle
– P1–3: the relay is closed for T1, then it is switched off for T2 and then it closes permanently
– P1–4: the relay switches cyclically to time T2 after time T1 has elapsed – it is switched off at the beginning of the cycle
– P1–5: the relay switches cyclically for time T1 after the time T2 has elapsed – it is switched on at the beginning of the cycle
Time setting:
– P0–0 – setting to seconds mode
– P0–1 – setting to minute mode
– P0–2 -set to clock mode
Settings:
– a short press of the SET button activates the time setting mode:
– T1 – the red display flashes and the time T1 can be set with the arrows
– T2 – the green display flashes and the time T1 can be set with the arrows
– saving of set values is enabled by repeated short press SET or automatically after 6sec of inactivity
– long press of the SET button allows to set time units and operating modes:
-P0 – setting sec (0) – min (1) – hr (2) using the arrows. The settings apply to both channels at the same time
-P1 – setting of operating modes 0–5, see above, also with arrows.
– saving of set values is enabled by repeated short press SET or automatically after 6sec of inactivity
The module does not have a separate Start button. The timing starts by connecting the input voltage
The product is not a stand-alone unit, it requires professional installation.
