Kategorija: Elektronske komponente i moduli - Page 63

Kategorija: Elektronske komponente i moduli

RF širokopojasno pojačalo 0,1-2000MHz
700,00 RSD
RF širokopojasno pojačalo, 0,1-2000MHz RF antensko pojačalo Modul za RF pojačalo sa malim šumom i velikim pojačanjem širokopojasnog RF pojačala 30dB LNA modul ploče za kratke talase, FM radio, prijemnik za daljinsko upravljanje.

Dodaj u korpu
USB flash memorija SanDisk Cruzer Ultra 3.1 16GB ZJ CN
1.000,00 RSD
USB flash memorija SanDisk Cruzer Ultra 3.1 16GB ZJ CN.

Dodaj u korpu
USB flash memorija SanDisk Cruzer Blade Teardrope 64GB ZJ CN
1.300,00 RSD
USB flash memorija SanDisk Cruzer Blade Teardrope 64GB ZJ CN.

Dodaj u korpu
USB flash memorija SanDisk Cruzer Ultra 3.1 32GB ZJ CN
1.200,00 RSD
USB flash memorija SanDisk Cruzer Ultra 3.1 32GB ZJ CN.

Dodaj u korpu
Raspberry Pico CAN / RS485 5-12V modul
2.200,00 RSD
Raspberry Pico CAN / RS485 5-12V modul.

Wide range 5 – 12 V
SPI, CAN, RS485
Supply voltage
USB C
Screw terminal
5 V DC
6 – 12 V DC
Logic level 3.3 V
Operating temperature: -0 to + 70 °C.
CAN terminating resistor
120Ω, which if needed
enabled and disabled
can be performed
RS485 load resistance
120Ω, which if needed
enabled and disabled
can be performed
Compatible with all Raspberry pico Controllers

Dodaj u korpu
Raspberry Pi StromPi 3 UPS XL
7.000,00 RSD
Raspberry Pi StromPi 3 UPS XL.

Can be plugged directly onto the StromPi3
It is immediately charged completed pin header own protection / charging electronics
Increased safety: Since no chemical self-ignition is possible
Much longer life-duration than lithium ION tech-nologies
Up to 2 hours battery life

Type
Lithium iron phosphate (LiFePO4)
Capacitance
2000 mAh
Voltage
3.2 volts
Key features
Can be plugged directly onto the StromPi3
Is immediately charged […]

Dodaj u korpu
Kućište DIN za Raspberry Pi StromPi 3
3.600,00 RSD
Kućište DIN za Raspberry Pi StromPi 3.

Housing for a completely Raspberry Pi (3 od 4)-based UPS unit including battery
Active cooling
Low-profile heatsink and board for
Fan control and Powerbutton solution
Included in the scope of delivery
M4 threaded holes for mounting purposes
Suitable for DIN rail mounting
GPIO cover can be removed
Compatible with Raspberry 3 and 4

Compatible with Raspberry Pi 2, […]

Dodaj u korpu
Relejni modul 4x RTU 12V RS485 MCU
1.200,00 RSD
Relay communication: multi-unit network 485 communication, based on MBDBUS-RTU protocol, the default communication address is 1, the user can modify the address by command

IN1 – IN4 are used by the switch. The status of the switch is read by 485, not by the input control relay output.
1. S1 reset button
2. D5 running LED indicator

Specifications:

4 relays […]

Dodaj u korpu
Set flah ring i viljuškastih konektora 1000 u 1
2.100,00 RSD

Dodaj u korpu
Raspberry Pi Arduino ESP32 Micro:Bit set Joy-Pi razvojni sistem Advanced
40.000,00 RSD
Joy-Pi Advanced razvojni sistem: Raspberry Pi, Arduino, ESP32, Micro:bit
Joy-Pi Advanced je sveobuhvatan edukativni razvojni sistem koji integriše podršku za Raspberry Pi, Arduino, ESP32 i Micro:bit platforme. Ovaj komplet je dizajniran za učenje, prototipiranje i razvoj raznovrsnih elektronskih i IoT projekata, čineći ga idealnim za obrazovne ustanove, hobiste i inženjere.
Ključne karakteristike:

Kompatibilnost: Raspberry Pi 4, Arduino Nano, […]

Dodaj u korpu
Micro:Bit relejni modul
1.200,00 RSD
Micro:Bit relejni modul.

Input voltage: 5V
4-channel relay module
Max 10A / 128V relay

By the use of this module, the microbit mainboard can control 4 channel high power loads like TV, air conditioner, home door and also applies for smart home.

Dodaj u korpu
Arduino modul propeler
600,00 RSD
TRU COMPONENTS TC-9072488.

Fan module integrated chip L9110 driver can control reversing. It comes with mounting holes, compatible steering rudder control and high quality and efficiency propellers. It can easily blow out flame from lighters as far as 20 cm away. It is ideal for fire fighting robot and is essential for robot design and development.

Features

Controls […]

Dodaj u korpu
Senzor osvetljenja M5Stack U021
1.000,00 RSD
Senzor osvetljenja M5Stack U021.
The light intensity sensor unit from the M5Stack series is equipped with an adjustable photoresistor. A photoresistor is a light-controlled variable resistor. The resistance of a photo resistor decreases as the intensity of the incident light increases and vice versa. It has a photolitability that enables the acquisition of voltage-based fluctuations and […]

Dodaj u korpu
Senzor pokreta M5Stack U054 PIR HAT
1.000,00 RSD
Senzor pokreta M5Stack U054 PIR.

Detecting Range: 150cm
Delay time: 2s
Induction Angle: < 100°
IDDQ : < 60uA
Op.T: -20 – 80 °C

Detection range: 150 cm
Delay time: 2 sec
Induction Angle: < 100°
IDDQ : < 60 uA

Dodaj u korpu
Senzor težine M5Stack U030 GPIO HX711
2.000,00 RSD
Senzor težine M5Stack U030.

Two selectable differential input channels
On-chip active low-noise PGA with selectable gain of 32, 64 and 128
On-chip power supply controller for analog load cells and ADC power supply
On-chip oscillator, no external component with optional external crystal required
On-chip power-on-Reset
Simple digital control and serial interface: Pen-controlled control, no programming required
Selectable 10 PLC or 80 PLC […]

Dodaj u korpu
Senzor vlažnosti M5Stack U101
2.500,00 RSD
Senzor vlažnosti M5Stack U101.

Capacitive measuring plate (corrosion resistant)
Integrated 5W power water pump
LEGO compatible holes

Dodaj u korpu
ESP32 PICO 04 mikrokontoler M5Stack K048
6.000,00 RSD
ESP32 PICO 04 mikrokontroler M5Stack K048 (CoreInk)
M5Stack CoreInk je kompaktan razvojni komplet baziran na ESP32-PICO-D4 čipu, opremljen 1.54″ crno-belim E-Ink displejem rezolucije 200×200 piksela. Zahvaljujući niskoj potrošnji energije i mogućnosti zadržavanja prikaza bez napajanja, idealan je za IoT terminale, elektronske oznake i uređaje za prikaz informacija.
Tehničke karakteristike:

Mikrokontroler: ESP32-PICO-D4 (dual-core, 240 MHz, 520 KB SRAM)
Flash memorija: […]

Dodaj u korpu
ESP32 PICO mikrokontoler M5Stack K041 QR Code
6.800,00 RSD
ESP32 PICO mikrokontroler M5Stack K041 QR Code
M5Stack K041 je kompaktan, integrisani mikrokontrolerski modul baziran na ESP32-PICO-D4 SoC-u sa integrisanim Wi-Fi i Bluetooth funkcijama. Modul je specijalno dizajniran za projekte koji uključuju prepoznavanje QR kodova i barkodova, zahvaljujući integrisanoj kameri i optimizovanom softveru za dekodiranje slike.
Tehničke karakteristike:

Mikrokontroler: ESP32-PICO-D4 (dual-core, 240 MHz)
Memorija: 520 KB SRAM, 4 MB […]

Dodaj u korpu
ESP32 mikrokontoler M5Stack K010
9.000,00 RSD
ESP32 mikrokontroler M5Stack K010
M5Stack K010 je napredni razvojni komplet baziran na ESP32-D0WDQ6-V3 mikrokontroleru, namenjen za brzi razvoj IoT aplikacija. Opremljen je bogatim skupom integrisanih komponenti, uključujući WiFi i Bluetooth konektivnost, kapacitivni TFT ekran, vibracioni motor, zvučnik, RTC, IMU senzor i PDM mikrofon, što ga čini idealnim za prototipove i edukativne projekte.
Tehničke karakteristike:

Procesor: ESP32-D0WDQ6-V3 (Xtensa® dual-core […]

Dodaj u korpu
Modul Joy-it SB 2x dugme

Modul Joy-it SB 2x Button.

Min. operating voltage

3V

Max. operating voltage

12V

Height

8mm

Length

27mm

Width

22mm

Certification

LOGIC LEVEL
standard long-range
high-active
If VCC & GND is swapped

Product type

PCB extension board

This module with 2 buttons and integrated pull-UP resistors, can be permanently soldered, connected with cables, or used on a breadboard.
Connected as standard, the module is operated in high-active mode.
However, the module can also be operated in […]

Saznaj više